Table 34, Table 34: sip extension configuration parameters, Table 34: sip – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 121: Extension configuration parameters
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 120 of 303
Table 34: SIP Extension Configuration Parameters - Basic Settings
General
Extension
The extension number associated with the user.
CallerID Number
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Permission
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
SIP/IAX Password
Configure the password for the user. A random secure password will be
automatically generated. It is recommended to use this password for
security purpose.
Support Hot-Desking Mode
If enabled, SIP Password will accept only alphabet characters and digits;
AuthID will be changed to the same as Extension.
Auth ID
Configure the authentication ID for the user. If not configured, the
extension number will be used for authentication.
Enable Voicemail
Enable voicemail for the user. The default setting is "Yes".
Voicemail Password
Configure voicemail password (digits only) for the user to access the
voicemail box. A random numeric password is automatically generated. It
is recommended to use the random generated password for security
purpose.
Skip Voicemail Password
Verification
When user dials voicemail code, the password verification IVR is skipped.
If enabled, this would allow one-button voicemail access. By default this
option is disabled.
Disable This Extension
If selected, this extension will be disabled on the UCM6100.
Note:
The disabled extension still exists on the PBX but can’t be used on the
end device.
Enable LDAP
If enabled, this extension will be added to LDAP Phonebook PBX list; if
disabled, this extension will be skipped when creating LDAP Phonebook.
User Settings
First Name
Configure the first name of the user. The first name can contain