Configure ivr, Table 61: ivr configuration parameters, Table 61: ivr – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 184: Configuration parameters

Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 183 of 303
IVR
CONFIGURE IVR
IVR configurations can be accessed under the UCM6100 Web GUI->PBX->Call Features->IVR. Users
could create, edit, view and delete an IVR.
• Click on "Create New IVR" to add a new IVR.
• Click on
to edit the IVR configuration.
• Click on
to delete the IVR.
Table 61: IVR Configuration Parameters
Basic Settings
Name
Configure the name of the IVR. Letters, digits, _ and - are allowed.
Extension
Enter the extension number for users to access the IVR.
Dial Other Extensions
If enabled, all callers to the IVR can dial other extensions. The default
setting is "No".
Dial Trunk
If enabled, all callers to the IVR is allowed to use trunk. The permission
must be configured for the users to use the trunk first. The default setting
is "No".
Permission
Assign permission level for outbound calls if "Dial Trunk" is enabled. The
available permissions are "Internal",
"Local",
"National"
and
"International" from the lowest level to the highest level. The default
setting is "Internal". If the user tries to dial outbound calls after dialing into
the IVR, the UCM6100 will compared the IVR's permission level with the
outbound route's privilege level. If the IVR's permission level is higher
than (or equal to) the outbound route's privilege level, the call will be
allowed to go through.
Welcome Prompt
Select an audio file to play as the welcome prompt for the IVR. Click on
"Prompt" to add additional audio file under web GUI->Internal
Options->IVR Prompt.
Digit Timeout
Configure the timeout between digit entries. After the user enters a digit,
the user needs to enter the next digit within the timeout. If no digit is
detected within the timeout, the UCM6100 will consider the entries
complete. The default timeout is 3 seconds.
Response Timeout
After playing the prompts in the IVR, the UCM6100 will wait for the DTMF