Sip settings/tcp and tls, Table 88: sip settings/tcp and tls – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 262
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 261 of 303
Session Expire
Configure the maximum session refresh interval (in seconds). The default
setting is 1800.
Min SE
Configure the minimum session refresh interval (in seconds). The default
setting is 90.
Session Refresher
Select the session refresher to be UAC or UAS. The default setting is
UAC.
SIP SETTINGS/TCP AND TLS
Table 88: SIP Settings/TCP and TLS
TCP Enable
Configure to allow incoming TCP connections with the UCM6100. The
default setting is "No".
TCP Bind Address
Configure the IP address for TCP server to bind to. 0.0.0.0 means binding
to all interfaces. The port number is optional. If not specified, 5060 will be
used.
TLS Enable
Configure to allow incoming TLS connections with the UCM6100. The
default setting is "No".
TLS Bind Address
Configure the IP address for TLS server to bind to. 0.0.0.0 means binding
to all interfaces. The port number is optional. If not specified, 5061 will be
used.
Note:
The IP address must match the common name (hostname) in the
certificate. Please do not bind a TLS socket to multiple IP addresses. For
details on how to construct a certificate for SIP, please refer to the
following document:
TLS Client Protocol
Select the TLS protocol for outbound client connections. The default
setting is TLSv1.
TLS Do Not Verify
If enabled, the TLS server's certificate won't be verified when acting as a
client. The default setting is "Yes".
TLS Self-Signed CA
This is the CA certificate if the TLS server being connected to requires
self-signed certificate, including server's public key. This file will be
renames as "TLS.ca" automatically.
Note:
The size of the uploaded ca file must be under 2MB.