Troubleshooting, Ethernet capture, Figure 184: ethernet capture – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 298
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 297 of 303
The default syslog level for all modules is "error", which is recommended in your UCM6100 settings
because it can be helpful to locate the issues when errors happen.
Some typical modules for UCM6100 functions are as follows and users can turn on "notic" and "verb"
levels besides "error" level.
pbx: This module is related to general PBX functions.
chan_sip: This module is related to SIP calls.
chan_dahdi: This module is related to analog calls (FXO/FXS).
app_meetme: This module is related to conference bridge.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
Syslog is usually for debugging and troubleshooting purpose. Turning on all levels for all syslog modules is
not recommended for daily usage. Too many syslog print might cause traffic and affect system
performance.
--------------------------------------------------------------------------------------------------------------------------------------------
TROUBLESHOOTING
On the UCM6100, users could capture traces, ping remote host and traceroute remote host for
troubleshooting purpose under Web GUI->Maintenance->Troubleshooting.
ETHERNET CAPTURE
The captured trace can be downloaded for analysis. Also the instructions or result will be displayed in the
web GUI output result.
Figure 184: Ethernet Capture