beautypg.com

Internal options, Internal options/general, Table 76: internal options/general – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 252: Table

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 251 of 303

INTERNAL OPTIONS

This section describes internal options that haven't been mentioned in previous sections yet. The settings

in this section can be applied globally to the UCM6100, including general configurations, jitter buffer, RTP

settings, ports config and STUN monitor. The options can be accessed via Web GUI->PBX->Internal

Options.

INTERNAL OPTIONS/GENERAL

Table 76: Internal Options/General

General Preferences

Global OutBound CID

Configure the global CallerID used for all outbound calls when no other

CallerID is defined with higher priority. If no CallerID is defined for

extension or trunk, the global outbound CID will be used as CallerID.

Global OutBound CID Name

Configure the global CallerID Name used for all outbound calls. If

configured, all outbound calls will have the CallerID Name set to this

name. If not, the extension's CallerID Name will be used.

Operator Extension

Specify the operator extension, which will be dialed when users presses 0

to exit voicemail application. The operator extension can also be used in

IVR option.

Ring Timeout

Configure the number of seconds to ring an extension before the call

goes to the user's voicemail box. The default setting is 60.

Note:

This is the global value used for each extension if "Ring Timeout" field is

left empty on the extension configuration page.

Record Prompt

If enabled, users will hear voice prompt before recording is started or

stopped. For example, before recording, the UCM6100 will play voice

prompt "The call will be recorded". The default setting is "No".

Extension Preferences

Enforce Strong Passwords

If enabled, strong password will be enforced for the password created on

the UCM6100. The default setting is enabled.

Strong Password Rules:
1. Password for voicemail, voicemail group, outbound route, DISA, call

queue and conference requires non-repetitive and non-sequential

This manual is related to the following products: