beautypg.com

Alert log – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 278

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 277 of 303

Figure 159: System Events->Alert Events Lists: System Reboot

Detect Cycle: The UCM6100 will check the system reboot based on this cycle. Users can enter

the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.

4. System Crash

Figure 160: System Events->Alert Events Lists: System Crash

Detect Cycle: The UCM will detect the event at each cycle based on the specified time. Users can

enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.

Click on the switch

to turn on/off the alert and Email notification for the event. Users

could also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email

Notification On", "Email Notification Off" to control the alert and Email notification configuration.

ALERT LOG

Under Web GUI->Status->System Events->Alert Log, system messages from triggered system events

are listed as alert logs. The following screenshot shows system crash alert logs.

This manual is related to the following products: