Grandstream UCM6100 User Manual for 1.0.9.25 - Manual (Page 81)

Firmware Version 1.0.9.25 UCM6100 Series IP PBX User Manual Page 80 of 303
Server Specify the SMTP server when using type "Client".
Username
Username is required when using type "Client". Normally it's the Email
address.
Password
Password to login for the above Username (Email address) is required
when using type "Client".
Display Name Specify the display name in the FROM header in the Email.
Sender
Specify the sender's Email address.
For example, [email protected].
The following figure shows a sample Email settings on the UCM6100, assuming the Email is using
smtp.gmail.com as the SMTP server.
Figure 48: UCM6100 Email Settings
Once the configuration is finished, click on "Test". In the prompt, fill in a valid Email address to send a test
Email to verify the Email settings on the UCM6100.
TIME SETTINGS
AUTO TIME UPDATING
The current system time on the UCM6100 is displayed on the upper right of the web page. It can also be
found under Web GUI->Status->System Status->General.
To configure the UCM6100 to update time automatically, go to Web GUI->Settings->Time
Settings->Time Auto Updating.