beautypg.com

Create new iax extension – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 126

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 125 of 303

Skip Trunk Auth

· If set to ‘yes’, users can skip entering the password when making

outbound calls.

· If set to ‘By Time’, users can skip entering the password when making

outbound calls during the selected time condition.

· If set to ‘No’, users will be asked to enter the password when making

outbound calls.

Time Condition for Skip Trunk

Auth

If ‘Skip Trunk Auth’ is set to ‘By Time’, select a time condition during which

users can skip entering password when making outbound calls.

Dial Trunk Password

Configure personal password when making outbound calls via trunk.

Table 37: SIP Extension Configuration Parameters - Specific Time

Specific Time

Time Condition

Click to add Time Condition to configure specific time for this extension.

CREATE NEW IAX EXTENSION

The UCM6100 supports Inter-Asterisk eXchange (IAX) protocol. IAX is used for transporting VoIP

telephony sessions between servers and terminal devices. IAX is similar to SIP but also has its own

characteristic. For more information, please refer to RFC 5465.

To manually create new IAX user, go to Web GUI->PBX->Basic/Call Routes->Extensions. Click on

"Create New User"->"Create New IAX Extension" and a new dialog window will show for users to fill in the

extension information. The configuration parameters are as follows.

Table 38: IAX Extension Configuration Parameters - Basic Settings

General

Extension

The extension number associated with the user.

CallerID Number

Configure the CallerID Number that would be applied for outbound calls

from this user.

Note:

The ability to manipulate your outbound Caller ID may be limited by your

VoIP provider.

Permission

Assign permission level to the user. The available permissions are

"Internal", "Local", "National" and "International" from the lowest level to

the highest level. The default setting is "Internal".

Note:

Users need to have the same level as or higher level than an outbound

rule's privilege in order to make outbound calls using this rule.

This manual is related to the following products: