Gasboy Site Controller III Start-Up - Manual (Page 92)

Pump/Dispenser Automatic Test
Page 80 MDE-4375 CFN Series Site Controller III Start-Up Manual · June 2005
Reader Entries and Fuel Point
If your system was ordered with the reader entry option, you must enter data at the card reader
with every Fuel Point transaction. This entered data is combined with the data already
programmed into the vehicle module.
1 Insert the wired-hose into the vehicle’s fill pipe, or, park the vehicle over the ground loop,
whichever is applicable.
2 Go to the card reader that is assigned to the Fuel Point controlling this hose.
The reader will be scrolling broadcast messages, or a SLIDE CARD message.
(The card reader is assigned to a Fuel Point reader in the FUELPT.BIN configuration
program.)
3 On the keypad, press the pump number that you are using, followed by the ENTER key.
The display now prompts you to enter certain data. Follow the prompts until finished.
4 The pump should turn on when all entries have been successfully entered.
Obtaining a Receipt for Fuel Point Transactions
If Using an Island Card Reader
1 Once the transaction has been completed, go to the Island Card Reader.
The reader will be scrolling broadcast messages, or a SLIDE CARD message.
2 Select the pump number you just used, followed by the ENTER key.
There is no further prompting for the receipt. The receipt will print for the last transaction that
occurred at that pump within the last 20 minutes. Since only the last transaction at that pump is
available as a receipt, you must get your receipt before allowing another transaction to
complete at that pump.
If Using an Electronic Dispenser with a Built-in Printer
After the transaction has completed, the receipt will be printed automatically, or the display
may prompt for the receipt, depending on the configuration in SYS_PAR.BIN.
Master/Satellite Dispensers with Fuel Point
The design of the Fuel Point system allows a nozzle ring on the master dispenser only. That
means the master nozzle must always be inserted in the truck’s fill pipe with the tank ring in
order for the satellite dispenser to operate. If the truck must be able to pull into the fuel lane
from either direction, then you may add a tank ring to both fill pipes.
Using the Chain Pump Feature with Fuel Point
The chain pump feature is used when activation of a fuel dispenser also turns on a bank of
fluid reels. In this application, the dispenser is known as the master of the chain. Only the
master of the chain has a nozzle ring, so its hose must remain in the fill pipe until all fueling
and fluid hoses are finished pumping.