Gasboy Site Controller III Start-Up - Manual (Page 21)

MDE-4375 CFN Series Site Controller III Start-Up Manual · June 2005 Page 9
Site Information
6. Load Fuel Inventory
(Reference: Site Manager’s Manual, LO IN command)
Use the following table to load the initial inventory amounts and the reorder levels for your
fuel products. Once you have loaded the initial inventory amounts, you will use ADd
INventory to add to the inventory amount for the product. You will also use this command
later when you load inventory for your merchandise products, but you need to define these
products first.
Note: Normally fuel is tracked using the LOad TAnk command (see 7. Load Tank below);
however, this command can also be used.
7. Load Tank
(Reference: Site Manager’s Manual, LO TA command)
Use this table to enter the initial tank inventory, product code and the reorder level for each
tank. See also
6. Load Fuel Inventory above.
Product Number Quantity Reorder Level
Tank Number Quantity Product Code Reorder Level