Gasboy Site Controller III Start-Up - Manual (Page 25)

MDE-4375 CFN Series Site Controller III Start-Up Manual · June 2005 Page 13
Site Information
12. Load Tax
(Reference: Site Manager’s Manual, LO TAX command)
Use the following table to enter the names of the tax accumulators. Tax accumulators keep a
running total of taxes collected in up to eight categories. Tax formulas are specified in system
configuration or by using the TAX command.
13. Lockout Type
(Reference: Site Manager’s Manual, LOC CA or UN CA command)
14. Authorization and Limitation Codes
(Reference: Card Encoding Manual, Site Manager’s Manual, LO A, LO LI commands)
If the customer is using private-issue cards, you may also need to load authorization codes and
limitation codes for the cards. Values for these codes should have been assigned when the
cards were encoded. Special templates for defining these codes appear in the Card Encoding
Manual.
15. CRON Commands
(Reference: Site Manager’s Manual, LO CR command)
Use the following table to define any cron commands you wish to have executed. You may
find some crons already loaded.
Tax # Name (up to 7 character)
Indicate type of lockout: Positive Negative
Command # Command