Gasboy Site Controller III Start-Up - Manual (Page 17)

MDE-4375 CFN Series Site Controller III Start-Up Manual · June 2005 Page 5
Site Information
2 – Site Information
Before the Site Controller III system is operational, you must load in site information. This
section provides a template for you to fill in the information needed to perform the start-up
commands in the
Start-up Commands chapter. Do not perform the commands at this time.
Confirm with the customer and fill in the information that he or she will be using (e.g., fuel
authorizations, limitations, etc.). Successful startup requires coordination between separate
components of the system: installation, card encoding, and operation. Each item contains a
manual reference where you can find additional information. For private-issue cards, the
system identification, fuel authorization, fuel limitation codes, and price levels are encoded on
the access cards and then entered into the system via commands. The commands you enter
must match what is encoded on the cards. The Card Encoding Manual explains the encoding
of these items.
The tables in this section are meant to be reused. Make a photocopy of this section
before filling in table data.
1. Communication Port Settings
(Reference: Configuration Manual)
Indicate the device connected to each of the ports you will use and the baud rates, if known.
The baud rate must match the baud rate of the device that is being connected to the port. Port
configuration assignments and baud rates are done through the site configuration. Port wiring
is no longer set by jumpers. You must use the correct cable for the devices connected. Refer
to the Installation Manual for cabling requirements.
Port Device Baud Rate
1
4
5
6
COM1
COM2
COM3
COM4
COM5
COM6
LPT1 Printer (Y/N) N/A