Gasboy Site Controller III Start-Up - Manual (Page 60)

Jumpers & Switch Settings
Page 48 MDE-4375 CFN Series Site Controller III Start-Up Manual · June 2005
Switch SW1
Pumps and Dispensers
If you are using GASBOY Series 9800 pumps and dispensers, there are switches that must be
set correctly to insure proper operation of your CFN system. See the Series 9800 Installation/
Operation Manual for details.
If you are using a Gilbarco ® CRIND device or another pump interface (Tokheim DPTs,
Wayne ® , etc.) refer to C09146 Pumps Interface Manual.
Standalone Star Printer
The switches on the standalone Star printer are set at the factory and should be correct. If
change is needed, refer to the CFN Diagnostic Manual for details.
Switch Setting
1 ON
2 ON
FPR Address Switch 3 Switch 4
1 OFF OFF
2 OFF ON
3 ON OFF
4 ON ON