Gasboy Site Controller III Start-Up - Manual (Page 106)

Start-up Commands
Page 94 MDE-4375 CFN Series Site Controller III Start-Up Manual · June 2005
Figure 12-35: Example of LO V;IC Command with Prompts
Reset Transaction File
The following command sequence enables you to reset and initialize the transaction file
(
Figure 12-36 ).
The command sequence is explained in Explanation of Commands below.
Figure 12-36: Example of Reset Transaction File Command Sequence
Explanation of Commands
FIX TR;I Resets the transaction file and sets all transaction numbers to -1. Use this
command only at start-up as it is irreversible; all stored transactions will be
made unreadable. Answer yes, y, to the VERIFY prompt and press RETURN.
RE TR;A Resets all transaction file pointers.
RE TR:I Clears any temporary or transaction in progress files.
LO TR 0 Loads a new transaction number of 0 (zero).
RE TR 1 Resets the transaction pointer to begin at transaction 1.
R* LO V;IC
Vehicle number? 100
Odometer reading? 22954
Vehicle number?
R*
This command procedure should only be done at start-up.
CAUTION
R* FIX TR;I
Verify (y/n)? y
R* RE TR;A
Verify (y/n)? y
R* RE TR;I
Verify (y/n)? y
R* RE TR 0
R* RE TR 1
Verify (y/n)? y
R*