Basler Electric BE1-11t - Manual (Page 465)

9424200995 Rev H 453
Turn-On Voltage
Contact-sensing turn-on voltages are listed in Table 205.
Table 205. Contact-Sensing Turn-On Voltages
Style Option Nominal Input Voltage
Contact-Sensing Turn-On Voltage
*
Jumper Installed
(Low Position) †
Jumper Not Installed
(High Position) †
Txx1xxxxxxxxxx 48 Vdc or 125 Vac/dc 26 to 38 Vdc
69 to 100 Vdc
56 to 97 Vac
Txx2xxxxxxxxxx 125/250 Vac/dc
69 to 100 Vdc
56 to 97 Vac
138 to 200 Vdc
112 to 194 Vac
Txx3xxxxxxxxxx 24 Vdc n/a Approx. 5 Vdc
* AC voltage ranges are calculated using the default recognition time (4 ms) and debounce time (4 ms).
† Voltage ranges depend on jumper configurations. See the Contact Inputs and Outputs chapter for more
information.
Input Burden
Burden values shown in Table 206 assume nominal value of input voltage applied.
Table 206. Contact-Sensing Input Burden
Style Option Nominal Input Voltage
Burden
Jumper Installed
(Low Position)
Jumper Not Installed
(High Position)
Txx1xxxxxxxxxx 48 Vdc or 125 Vac/dc 22 k Ω 53 k Ω
Txx2xxxxxxxxxx 125/250 Vac/dc 66 k
Ω
123 k
Ω
Txx3xxxxxxxxxx 24 Vdc n/a 6 k
Ω
Recognition Time
Programmable ........................................................... 4 to 255 ms
Note
All timing specifications are for the worst-case response. This includes
output contact operate times and standard BESTlogicPlus operation
timing but excludes input debounce timing and nonstandard logic
configurations. If a nonstandard logic scheme involves feedback, then
one or more BESTlogicPlus update rate delays must be included to
calculate the worst-case delay. An example of feedback is logic
outputs driving logic inputs. For more information, see BESTlogicPlus.
Terminals
IN1 ............................................................................. B1, B2
IN2 ............................................................................. B3, B4
IN3 ............................................................................. B5, B6
IN4 ............................................................................. B7, B8
IN5 ............................................................................. E1, E2
IN6 ............................................................................. E3, E4
IN7 ............................................................................. E5, E6
BE1-11t Specifications