Basler Electric BE1-11t - Manual (Page 207)

9424200995 Rev H 195
BESTnet
™Plus
BE1-11t Transformer Protection Systems with an Ethernet port have a web page interface that can be
used to view BE1-11t status, real-time data, demand data, faults, sequence of events, and power quality.
Refer to the
Communication chapter for information about configuring the BE1-11t to communicate
through the Ethernet port. Verify that Enable Web Pages is selected on the Settings, Communications,
Ethernet screen in the Settings Explorer of BESTCOMSPlus
® or on the Settings > Communication >
Ethernet screen of the front-panel display. Using a web browser, enter the IP Address of your BE1-11t in
the address bar. The protection system’s IP address is found on the front-panel display under Settings >
Communication > Ethernet. Figure 147 shows an example for a BE1-11t with an IP address of
10.0.129.101.
Figure 147. Address Bar of Web Browser
Status Page
Figure 148 illustrates the Status (home) page. Device information, firmware version, breaker status,
lockout status, alarm status, targets, local inputs status, and local outputs status are shown on this page.
A green indicator lights to indicate an energized state for inputs and outputs.
Figure 148. Status Page (Home Page)
Real Time Data
Figure 149 illustrates the Real Time Data page. Values for currents, frequency, voltages, and power are
shown on this page.
BE1-11t BESTnet
™Plus