Basler Electric BE1-11t - Manual (Page 144)

132 9424200995 Rev H
Figure 93. Setting Group Setup Screen
Table 52. Operational Settings
Setting Range Purpose Default
Mode
Disabled
Discrete Inputs
Binary Inputs Sets the mode of the setting group selection function.
(If Auto mode is desired, logic mode must be either 1 or
2.)
Disabled
Source
CT Circuit 1 or CT
Circuit 2 n/a
n/a
Switch
Threshold
0 to 25A (5A CTs)
0 to 5A (1A CTs) Measured current of the SG0 Monitor Setting that must
be exceeded for a setting group change to occur. (Set in
increments of 0.01A)
0
Switch
Time
0 = Disabled
1 to 60 minutes Time, in minutes, that determines when a setting change
occurs once the Switch Threshold setting is exceeded.
0
Return
Threshold
0 to 25A (5A CTs)
0 to 5A (1A CTs) Measured current of the SG0 Monitor Setting that the
monitored current must decrease below in order for a
return to SG0. (Set in increments of 0.01A)
0
Return
Time
0 = Disabled
1 to 60 minutes Time, in minutes, that determines when a return to SG0
will occur once the monitored current has decreased
below the Return Threshold setting.
0
Setting Groups BE1-11t