Interlogix NS3550-2T-8S User Manual - Manual (Page 97)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
97
。 After the “Factory” button is pressed and rebooted, the system will be loaded default settings, except IP address.
To reset the Industrial Managed Switch to the Factory default setting, you can also press the hardware reset
button at the front panel for about more than 10 seconds. After the device is rebooted, all configurations will
be loaded to default setting including IP address. You can login the management WEB interface within the
same subnet of 192.168.0.xx.
4.2.25 System Reboot
The Reboot page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user will
re-access the WEB interface about 60 seconds later. The System Reboot screen in Figure 4-2-36 appears.
Figure 4-2-36: System Reboot Page Screenshot
Buttons
: Click to reboot the system.
: Click to return to the web main page without rebooting the system.