Interlogix NS3550-2T-8S User Manual - Manual (Page 49)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
49
2.2.3 Wall Mount Plate Mounting
To install the Industrial Managed Switch on the wall, please follow the instructions below.
In the installation steps below, this Manual use NS3550-2T-8S (IFS 8 Port Industrial Gigabit Switch) as
the example. However, the steps for IFS Industrial Gigabit PoE+ Switch are similar.
Step 1: To remove the Industrial Managed Switch from the DIN-Rail, use the screwdriver to loosen the screws and remove the
DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial Managed Switch.
Step 3: Use the screws to screw the wall mount plate on the Industrial Managed Switch.
Step 4: Use the hook holes at the corners of the wall mount plate to hang the Industrial Managed Switch on the wall.
Step 5: To remove the wall mount plate, reverse steps above.