Interlogix NS3550-2T-8S User Manual - Manual (Page 77)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
77
The page includes the following fields:
Object Description
• Mode Indicates the UPnP operation mode. Possible modes are:

Enabled: Enable UPnP mode operation.

Disabled: Disable UPnP mode operation.
When the mode is enabled, two ACEs are added automatically to trap UPNP
related packets to CPU. The ACEs are automatically removed when the mode is
disabled.
• TTL The TTL value is used by UPnP to send SSDP advertisement messages. Valid
values are in the range from 1 to 255.
•
Advertising Duration The duration, carried in SSDP packets, is used to inform a control point or control
points about how often it or they should receive an SSDP advertisement message
from this switch. If a control point does not receive any message within the
duration, it may suggest that the switch no longer exists. Due to the unreliable
nature of UDP, as standard it is recommended that such refreshment of
advertisements to be done at less than one-half of the advertising duration. In the
implementation, the switch sends SSDP messages periodically at the interval
one-half of the advertising duration minus 30 seconds. Valid values are in the
range from 100 to 86400.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
Figure 4-2-11: UPnP Devices shows on Windows My Network Places