Interlogix NS3550-2T-8S User Manual - Manual (Page 317)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
317
4.16.3 Port Configuration
This section allows the user to inspect and configure the current PoE port settings ; screen in Figure 4-16-3 appears.
Figure 4-16-3: Power over Ethernet Configuration Screenshot
The page includes the following fields:
Object Description
• PoE Mode
There are three modes for PoE mode.

Enable: enable PoE function..

Disable: disable PoE function.

Schedule: enable PoE function in schedule mode.
• Schedule Indicates the schedule profile mode. Possible porifles are:

Profile1

Profile2

Profile3

Profile4
• AF/AT Mode
Allows user to select 802.3at or 802.3af compatibility mode. The default value is
802.3at mode. This function will affect PoE power reservation on Classification
power limit mode only as 802.3af mode and system are going to reserve a
maximum of 15.4W for PD that supports Class3 level. IEEE 802.3at mode and
system are going to reserve 30.8 watts for PD that supports Class4 level. Class1
to class3 level in the 802.3at mode will reserve the same PoE power in the
802.3af mode.
• Priority
The Priority represents PoE ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in the case when total power consumption has been over total
power budget. In this case the port with the lowest priority will be turned off, and
offer power for the port of higher priority.
• Power Allocation
It can limit the port PoE supply watts. Per port maximum value must be less than
15.4 / 30.8 watts, and total ports values must be less than the Power
Reservation value. Once power overload is detected, the port will auto shut
down and keep on detection mode until PD’s power consumption is lower than
the power limit value
NS3552-8P-2S = 30.8 watts for per port PoE output