Interlogix NS3550-2T-8S User Manual - Manual (Page 252)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
252
The page includes the following fields:
Port State
These settings are common for all of the Authentication Servers.
Object Description
• Timeout
The Timeout, which can be set to a number between 3 and 3600 seconds, is the
maximum time to wait for a reply from a server.
If the server does not reply within this timeframe, we will consider it to be dead and
continue with the next enabled server (if any).
RADIUS servers are using the UDP protocol, which is unreliable by design. In
order to cope with lost frames, the timeout interval is divided into 3 subintervals of
equal length. If a reply is not received within the subinterval, the request is
transmitted again. This algorithm causes the RADIUS server to be queried up to 3
times before it is considered to be dead.
• Dead Time
The Dead Time, which can be set to a number between 0 and 3600 seconds, is
the period during which the switch will not send new requests to a server that has
failed to respond to a previous request. This will stop the switch from continually
trying to contact a server that it has already determined as dead.
Setting the Dead Time to a value greater than 0 (zero) will enable this feature, but
only if more than one server has been configured.
RADIUS Authentication Server Configuration
The table has one row for each RADIUS Authentication Server and a number of columns, which are:
Object Description
• #
The RADIUS Authentication Server number for which the configuration below
applies.
• Enabled Enable the RADIUS Authentication Server by checking this box.
• IP Address/Hostname The IP address or hostname of the RADIUS Authentication Server. IP address is
expressed in dotted decimal notation.
• Port
The UDP port to use on the RADIUS Authentication Server. If the port is set to 0
(zero), the default port (1812) is used on the RADIUS Authentication Server.
• Secret
The secret - up to 29 characters long - shared between the RADIUS
Authentication Server and the switch.
RADIUS Accounting Server Configuration
The table has one row for each RADIUS Accounting Server and a number of columns, which are:
Object Description
• # The RADIUS Accounting Server number for which the configuration below
applies.
• Enabled
Enable the RADIUS Accounting Server by checking this box.
• IP Address/Hostname
The IP address or hostname of the RADIUS Accounting Server. IP address is
expressed in dotted decimal notation.
• Port The UDP port to use on the RADIUS Accounting Server. If the port is set to 0