Interlogix NS3550-2T-8S User Manual - Manual (Page 212)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
212
Figure 4-9-16: QoS Ingress Queue Policers Page Screenshot
The page includes the following fields:
Object Description
• Port The port number for which the configuration below applies.
•
Enable (E) Controls whether the queue policer is enabled on this switch port.
• Rate Controls the rate for the queue policer. The default value is 500. This value is
restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted to 1-3300
when the "Unit" is "Mbps".
This field is only shown if at least one of the queue policers is enabled.
•
Unit Controls the unit of measure for the queue policer rate as kbps or Mbps. The
default value is "kbps".
This field is only shown if at least one of the queue policers is enabled.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
4.9.14 Storm Control Configuration
Storm control for the switch is configured on this page.
There is a unicast storm rate control, multicast storm rate control, and a broadcast storm rate control. These only affect flooded
frames, i.e. frames with a (VLAN ID, DMAC) pair not present on the MAC Address table.