Interlogix NS3550-2T-8S User Manual - Manual (Page 228)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
228

Any: Any value is allowed ("don't-care").
• TCP URG
Specify the TCP "Urgent Pointer field significant" (URG) value for this ACE.

0: TCP frames where the URG field is set must not be able to match this
entry.

1: TCP frames where the URG field is set must be able to match this
entry.

Any: Any value is allowed ("don't-care").
 Ethernet Type Parameters
The Ethernet Type parameters can be configured when Frame Type "Ethernet Type" is selected.
Object Description
•
EtherType Filter Specify the Ethernet type filter for this ACE.

Any: No EtherType filter is specified (EtherType filter status is
"don't-care").

Specific: If you want to filter a specific EtherType filter with this ACE,
you can enter a specific EtherType value. A field for entering an
EtherType value appears.
•
Ethernet Type Value When "Specific" is selected for the EtherType filter, you can enter a specific
EtherType value. The allowed range is 0x600 to 0xFFFF but excluding
0x800(IPv4), 0x806(ARP) and 0x86DD (IPv6). A frame that hits this ACE matches
this EtherType value.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
: Return to the previous page.
4.10.4 ACL Ports Configuration
Configure the ACL parameters (ACE) of each switch port. These parameters will affect frames received on a port unless the
frame matches a specific ACE.
The ACL Ports Configuration screen in Figure 4-10-4 appears.