Interlogix NS3550-2T-8S User Manual - Manual (Page 259)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
259
Rx Packets Dropped radiusAccClientExt
PacketsDropped The number of RADIUS
packets that were received
from the server on the
accounting port and dropped
for some other reason.
Tx Requests radiusAccClientExt
Requests The number of RADIUS
packets sent to the server. This
does not include
retransmissions.
Tx Retransmissions radiusAccClientExt
Retransmissions The number of RADIUS
packets retransmitted to the
RADIUS accounting server.
Tx Pending
Requests radiusAccClientExt
PendingRequests The number of RADIUS
packets destined for the server
that have not yet timed out or
received a response. This
variable is incremented when a
Request is sent and
decremented due to receipt of
a Response, timeout, or
retransmission.
Tx Timeouts radiusAccClientExt
Timeouts The number of accounting
timeouts to the server. After a
timeout, the client may retry to
the same server, send to a
different server, or give up. A
retry to the same server is
counted as a retransmit as well
as a timeout. A send to a
different server is counted as a
Request as well as a timeout.
• Other Info This section contains information about the state of the server and the latest round-trip
time.
Name RFC4670 Name Description
IP Address - IP address and UDP port for the accounting
server in question.
State - Shows the state of the server. It takes one of
the following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP
communication is up and running and the
RADIUS module is ready to accept accounting
attempts.
Dead (X seconds left): Accounting attempts
were made to this server, but it did not reply
within the configured timeout. The server has
temporarily been disabled, but will get
re-enabled when the dead-time expires. The
number of seconds left before this occurs is
displayed in parentheses. This state is only
reachable when more than one server is
enabled.
Round-Trip
Time radiusAccClientExtRo
undTripTime The time interval (measured in milliseconds)
between the most recent Response and the
Request that matched it from the RADIUS
accounting server. The granularity of this
measurement is 100 ms. A value of 0 ms
indicates that there hasn't been round-trip
communication with the server yet.