Interlogix NS3550-2T-8S User Manual - Manual (Page 518)

IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
518
'us|ns' calculation results are shown in micro or nano seconds
'keep|reset' the action in case of total delay counter overflow - either 'keep' all results or 'reset' all results
'd2ford1' this is selecting to used two-way DMM for calculate one-way delay.
Syntax:
MEP dm config [] [] [uni|multi] [] [oneway|twoway] [std|prop] [rdtrp|flow] [] [] [us|ns]
[keep|reset] [d2ford1] [enable|disable]
Parameters:
: Instance number
: OAM PDU priority
uni|multi : Destination address is unicast or multicast
: This MEP id (0-0x1FFF)
oneway|twoway : DM is one-way or two-way
std|prop : Standard or Vitesse proprietary way(w/ follow-up packets) to send DM
rdtrp|flow : 2/4 timestamps selection
: Gap between 1DM/DMM to send in 10ms(10-65535).
: The number of last records to calculate(10 - 2000)
us|ns : Time resolution
keep|reset : The action to counter when overflow happens
d2ford1 : Enable to use DMM/DMR packets to calculate one-way DM
enable|disable: enable/disable
MEP Test Signal Configuration
Description:
MEP Test Signal configuration
'set|clear' is set or clear of DEI of transmitted LBM frame
'prio' is the priority (PCP) of transmitted TST frame
'mep' is the peer MEP-ID of target MEP - only used if 'mac_addr is 'all zero'
'no_seq|seq' is without and with transmitted sequence numbers
'rate' is the TST frame transmission bit rate in Mbps'
'size' is the size of the un-tagged TST frame - four bytes will be added for each tag
'allzero|allone|onezero' is pattern contained in the TST frame data TLV.
Syntax:
MEP tst config [] [set|clear] [] [] [no_seq|seq] [] [] [allzero|allone|onezero] [enable|disable]