KEYENCE LS-7600 - Manual (Page 91)

5-29
Chapter 5 Function Settings
5
Output Settings
Values measured in AREA1 and AREA2 can be processed in a variety of ways and output
as OUT1 and OUT2 signals. This section provides information on the details and methods
of output settings.
Possible Output Settings
The following output settings are possible.
• Area calculation:
The measured values of two-area points speci-
fied by area settings are used for calculation
processing.
• Number of averaging measurements: Set the number of measuring times.
• Measuring mode:
Measured values are output “as is” or proc-
essed as maximum and minimum timing output
values.
• Offset: An offset value is a desired value that can be
added to or subtracted from measured values.
• Analog output: Analog voltages are output according to the
measured values.
• Discrimination output: Set the details of output that turns ON accord-
ing to the judgment results of measured values.
Output Settings
Take the following procedure if the remote control console is used.
1
Set the [Slide Switch] key to PROG.
The LCD monitor changes to the PROGRAM SETUP screen from the RUN screen.
2
Press the [Down] key and move the
cursor to OUTPUT.
3
Press the [ENT] key.
The cursor frame is displayed on the
OUT1 side.
OUT1
CALC +1A1 +0A2
AVE 512
MEA-MODE NORMAL
OFFSET 0.00000
OUT2
CALC +0A1 +1A2
AVE 512
MEA-MODE NORMAL
OFFSET 0.00000
01/02/18
17:50:42
CAM1
PROG
P – 00
LIMIT
AREA
OUTPUT
CALIB
OPTION
A1 2
A2 2
OUT1
CALC +1A1 +0A2
AVE 512
MEA-MODE NORMAL
OFFSET 0.00000
OUT2
CALC +0A1 +1A2
AVE 512
MEA-MODE NORMAL
OFFSET 0.00000
01/02/18
17:50:42
CAM1
PROG
P – 00
LIMIT
AREA
OUTPUT
CALIB
OPTION
A1 2
A2 2