KEYENCE LS-7600 - Manual (Page 58)

4-8
Chapter 4 Operation Control
4
Switching Cameras
The CAMERA1 display on the upper right-hand side of the LCD monitor indicates the
image sensor camera of measuring head 1. The CAMERA2 display indicates the image
sensor camera of measuring head 2.
OUT1
12.34560
UPPER 1.00000
STANDARD 12.00000
LOWER
–1.00000
CAM1 CAM2
RUN
P – 00
01/02/18
17:50:42
OUT1
12.34560
UP 1.00000
STD 12.00000
LO –1.00000
NORMAL 512
OUT2
23.45670
UP 1.00000
STD 23.00000
LO –1.00000
NORMAL 512
CAM1 CAM2
RUN
P – 00
AREA1
HEAD1
DIA
AREA2
HEAD1
DIA
A1 2
A2 2
01/02/18
17:50:42
■
Single Value Display
Press the [SCREEN] key and select
CAMERA1, CAMERA2, or both
CAMERA1 and CAMERA2.
■ Both Value Display
1
Press the [Down] key so that the
screen selection cursor will be off.
2
Press the [SCREEN] key and select
CAMERA1, CAMERA2, or both
CAMERA1 and CAMERA2.
CAMERA1 and CAMERA2
can be selected at the same
time when two measuring
heads are connected.
In the simultaneous display
of CAMERA1 and
CAMERA2, the upper half of
the screen shows the
CAMERA1 area cursor, and
the lower half of the screen
shows the CAMERA2 area
cursor. The measuring
target is displayed in black
instead of its actual image.
Displays CAMERA2
Displays CAMERA1
Area
cursors