KEYENCE LS-7600 - Manual (Page 62)

4-12
Chapter 4 Operation Control
4
Program Changes
The following section provides information on how to call 16 programs saved in the LS-
7600 Series.
Names and Number of Programs
The selected program is displayed on the LCD
monitor next to the [PROGRAM No.] key.
Programs 0 through 15 (i.e., 16 programs in
total) can be registered.
UT1
3.45670
PPER 1.00000
TANDARD 10.00000
OWER –1.00000
CAM1
RUN
P – 00
01/02/18
17 50 42
Display
position
Programs are selected through the following functional components.
• Control panel
• External I/O terminals
• RS-232C interface
Note: The operation method varies with the P-SELECT setting as an environmental
setting. Refer to Program on page 6-5 for environment settings in detail.
P-SELECT setting Operation method
PANEL
TERMINAL
Control panel/RS-232C interface
I/O terminals (P1 through P4)
■
Control Panel
Press the [PROGRAM No.] key (Up or Down key) on the control panel.
The program numbers will be displayed in sequence by pressing the key repeatedly.
■
External I/O Terminals
External I/O terminals P1 through P4 on the rear panel of the controller can be used for
program selection. Refer to Section 7 I/O Terminals on page 7-1 for external I/O termi-
nals to be used and program numbers in detail.
■ RS-232C Interface
Commands sent by external devices through the RS-232C interface make it possible to
select programs. Refer to PROGRAM No. on page 8-12 for the RS-232C interface in
detail.