KEYENCE LS-7600 - Manual (Page 164)

8-2
Chapter 8 RS-232C
8
Specifications
The LS-7600 Series has RS-232C communications functions. The following section pro-
vides information on the RS-232C communications specifications of the LS-7600 Series
and the outline of communications settings that vary with the connecting device.
■ Compatible connector specifications
Modular 8-pin plug connector (RJ-4S)
■
Pin Arrangement
Pin number Signal name Description
1 (Not used) —
2 SD(TXD)
3 RD(RXD)
4 SG(GND) GND
5 (Not used) —
6 (Not used) —
7 (Not used) —
8 (Not used) —
Receives (inputs into itself)
data from external devices.
Transmits (outputs) data
to external devices.
8
7
6
5
4
3
2
1
❈ All unused terminals must be open. Do not connect any wires to them, otherwise the
LS-7600 Series may malfunction.
❈ The SG terminal is internally connected (common) with the 0-V power supply termi-
nal (terminal block 2) through a choke coil.
■
Communications Specifications
EIA RS-232C Compliance (Modem Definitions)
D-MODE NORMAL PRINTER 1/2 PLC (KV mode)
Communications method Full duplex
Synchronous method Start-stop synchronization
Transmission code ASCII
Data length 7/8bit 8bit
Stop length 1/2bit 1bit
Parity check No/Even/Odd Even
Baud rate 1200/2400/4800/9600/ 9600bps
19200/38400/57600/115200bps
Delimiter CR + LF CR STX + ETX
Flow control No
Refer to RS-232C on page 6-7 for communications specification settings.