KEYENCE LS-7600 - Manual (Page 49)

3-9
3
Chapter 3 Easy Setting Guide
Group Processing
In the following example, the average, maximum, or minimum value is calculated as criteria
from the measuring data on the group of targets. The results of output are displayed as
OUT2.
■
Set Values
Set item
Calibration
Tolerance setting
Area setting
Output
setting
AREA
Operation
Averaging
RUN mode
Offset
Set value
AREA 1
Head 1 DIA
Make settings if required.
A1: +1
A2: 0
Select the value according to the line speed.
Sample hold
No settings are required.
No settings are required.
Setting impossible
Setting impossible
Average
Setting impossible
Set the upper and lower limit values.
AREA 2
OUT 1 OUT 2
Option setting 12 pcs GROUP
■
Reference
Area Settings (Page 5-9)
Calibration Settings (Page 5-22)
Output Settings (Page 5-29)
Tolerance Settings (Page 5-49)
Option Settings (Page 5-55)
Other example
The average measured value of the 12 shafts is
used as criteria. The average measured value of portions
A through D is used as criteria.