KEYENCE LS-7600 - Manual (Page 124)

5-62
Chapter 5 Function Settings
5
Graph TIME
Take the steps below to set the display periods of trend graphs for OUT1 and OUT2
respectively. For details, refer to Trend Graph Display on page 4-4.
Setting Range
Select the periods from the following.
1m, 10m, 30m, 1H, 6H, 12H and 24H.
1
Press the [Up or Down] key and move the cursor to OUT1 of GRAPH-T.
2
Press the [ENT] key.
The cursor moves to the setting item.
3
Press the [Up or Down] key and
select the display period for OUT1 of
GRAPH-T.
4
Press the [ENT] key.
The input item is entered and the cursor
returns to OUT1 of the GRAPH-T.
5
Press the [Up or Down] key and move
the cursor to OUT2 of GRAPH-T. Then
take steps similar to the above 2
through 4.
LIMITS DEV
T-MODE ASYNC
D-UNIT mm
D-RES 0.00005
C-OUT SUB
GRAPH-T
OUT1 1m
OUT2 1m
STATS
OUT1 OFF
OUT2 OFF
GROUP OFF
APP-MODE OFF
Statistical Processing
Take the following steps to enable or disable statistical processing for OUT1 and OUT2
respectively and external or internal synchronous settings. Refer to Statistical Processing
on page 5-66 for details.
Setting Range
Select the statistical processing setting from the following:
• OFF:
No statistical processing is used.
• EXT: External synchronous setting is used.
• 1000 (value): Internal synchronous setting is used. The setting range is between 2
and 9999999.
1
Press the [Up or Down] key and move the cursor to STATS.
2
Press the [ENT] key.
The cursor moves to the setting item.