KEYENCE LS-7600 - Manual (Page 66)

5-4
Chapter 5 Function Settings
5
Default Values and Possible Setting Ranges
The following programs settings are made by default.
■
Area Settings (Page 5-9)
Head number (HEAD)
Area
Area display (A-DISP)
Focus monitor (FOCUS)
Area check
1, 2
Item Possible setting range
Function output setting (FUNCTION)
Edge detection threshold (LEVEL)
Averaging number (AVE)
Difference value (DIFF)
Difference
check
1
DIA
ON
5
OFF
FOCUS
50
1
1000
Default
ON, OFF
0 to 9
OFF (No area check), 2 to 127
1, 2, 4, 8, 16
1 to 9999 (in μ m, mm, inch, or mil)
Focus monitor, area check, or difference
check
10 to 99%
Diameter (DIA)
Top edge (T-EDGE)
Bottom edge (B-EDGE)
Segment (SEG)
Specified SEG edge number: -127 to +127
SEG mode: Edge (E) or Pitch (P)
■
Calibration Settings (Page 5-22)
Item Possible setting range Default
Calibration mode
T1-A/T1-B/T2-A/T2-B
THEORY Logic, 2-point, or 1-point calibration
-99.99995 to +99.99995mm ❈
■
Tolerance Settings (Page 5-49)
-99.99995 to +99.99995mm ❈
Item Default
HH output range (HH)
Threshold
mode
Reference
value mode
+40.00000
HI output range (HI) +30.00000
LO output range (LO) 0.00000
LL output range (LL) -10.00000
HOLD-H OFF
Possible setting range
-99.99995 to +99.99995mm ❈
OFF, -99.99995 to +99.99995mm ❈
OFF, -99.99995 to +99.99995mm ❈
HOLD-L OFF
STANDARD +10.00000
UPPER +1.00000
LOWER -1.00000
HOLD-H OFF
HOLD-L OFF