Kontron COMe Starterkit Eval T2 - Manual (Page 143)

COM Express Interfaces
2.22.9. Thermal Interface
COM Express provides the 'THRM#' and 'THRMTRIP#' signals, which are used for system
thermal management. In most current system platforms, thermal management is closely
associated with system power management. For more detailed information about the thermal
management capabilities of the COM Express Module, refer to the manufacturer's Module's
user's guide.
Table 47: Thermal Management Signal Descriptions
Signal Pin Description I/O Comment
THRM# B35 Thermal Alarm active low signal generated by the external
hardware to indicate an over temperature situation. This
signal can be used to initiate thermal throttling. I 3.3V
CMOS
THRMTRIP# A35 Thermal Trip indicates an overheating condition of the
processor. If 'THRMTRIP#' goes active the system
immediately transitions to the S5 State (Soft Off). O 3.3V
CMOS
PICMG ® COM Express ® Carrier Board Design Guide Rev. 2.0 / December 6, 2013
143/218