Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 191)

Index Index-5
SPD LOOP OUTPUT (P.299), 5-18
SPD LOOP PI INIT SEL , 5-18
SPD LOOP PI INIT VAL , 5-18
SPD LOOP PI LEAD FREQ (P.212), 5-19
SPD LOOP PI PROP GAIN (P.211), 5-19
SPD LOOP PI RESET , 5-19
SPD LOOP REFERENCE (P.295), 4-24
SPD LOOP SCAN TIME (P.019), 5-2
SPD SOURCE SELECT OUT (P.193), 4-22
SPEED FEEDBACK GAIN , 5-22
speed loop
block diagram, 5-1
current limits, 5-14
error signal, 5-12
feedback, 5-3
lag feature, 5-13
lead/lag, 5-11
PI block setup, 5-17
SPEED RAMP INPUT TP (P.198), 4-22
SPEED RAMP OUTPUT (P.199), 4-22
speed reference, 4-1
block diagram, final, 4-23
mode select, 4-23
OIM , 4-23
ramp, 4-16, 4-18
block diagram, 4-17
source block, 4-2
source select block diagram, 4-3
STOP DECEL SELECT (P.122), 4-22
STOP MODE SELECT (P.114), 4-23
stop sequencing, 2-2
coast/DB, 2-3
current limit, 2-4
ramp, 2-3
STOP SPEED THRESHOLD (P.113), 4-23
T
TACH LEAD FLT DELAY (P.228), 13-19
TACH LEAD FLT THRESH (P.227), 13-19
TACH LOSS SCR ANGLE (P.608), 13-12
tachometer
adjusting loss sensitivity, 13-12
reversed lead detection, 13-19
technical assistance, 1-2
telephone support, 1-2
TOP SPEED (P.011), 4-24
TORQUE REFERENCE (P.189), 6-5
TRIM MODE SELECT (P.110), 4-14
TRIM OUTPUT (P.197), 4-15
TRIM RANGE (P.109), 4-15
TRIM REF REGISTER (P.107), 4-15
TRIM REFERENCE SELECT (P.108), 4-16
trim setup, 4-13
Troubleshooting, 13-1
troubleshooting
technical assistance, 1-2
U
UNDERWIND ENABLE , 5-21, 6-5
W
winding applications, 5-20