Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 166)

C-4 FlexPak 3000 DC Drive Software Reference
CML PI PROP GAIN (P.301) 0.000 to 4.000 0.250
CML REF LIMIT SELECT (P.311) • 1 = SPD LOOP PI LIMITS
• 2 = REGISTER
1
CML REF RATE LIMIT (P.303) 1 to 1000 msec 40 msec
CNI PROG / RUN MODE (P.915) • 1 = STOP
• 2 = USE LAST REF
• 3 = USE TRMBLK CNTL
1
CONTROL SOURCE (P.000) • KEYPAD
• SERIAL
• TERMBLK
• NETWORK
KEYPAD
CT TURNS RATIO (P.010) • 139
• 208
• 417
• 833
• 2000
• 5230
• OTHER
n/a
CURRENT COMPOUNDING (P.209) –50 to 50% 0%
DECELERATION TIME (P.002) 0.1 to 300.0 seconds 5.0 seconds
DEVNET POLL MSG TYPE (P.913) • CONTROL ONLY
• CONTROL + CONFIG
CONTROL ONLY
DIG IN 0 SELECT (P.428) • 1 = BRUSH WEAR INPUT
• 2 = JOG SPEED SELECT
• 3 = OCL ENABLE
1
DIG OUT 1 CONTACT TYP (P.410) • NORMAL OPEN
• NORMAL CLOSED
NORMAL OPEN
DIG OUT 1 SELECT (P.409) • LEVEL DETECT 1 OUTPUT
• LEVEL DETECT 2 OUTPUT
• IN CURRENT LIMIT
• DRIVE READY
• NETW COMM STATUS
• NETW IN REG 1 ( BIT 0)
• NETW IN REG 2 ( BIT 0)
• NETW IN REG 3 ( BIT 0)
LEVEL DETECT 1
OUTPUT
Table C.1 – Parameter Settings Quick Reference Table (Continued)
Parameter
Parameter Selection/
Adjustment Range
Initial Factory
Setting (Default)
Your Data
Date Setting