Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 114)

10-8 FlexPak 3000 DC Drive Software Reference
10.3 Configuring Parameters for the AutoMax Network
These parameters are only available if the AutoMax Network Communication board is
installed. For more information on the board and parameters, see the AutoMax
Network Communication board manual (D2-3318).
AMX NETW REF SELECT (P.911)
AutoMax Network
reference selection. Parameter Range: DIRECT
BROADCAST n
where n = 1 to 8
Default Setting: DIRECT
Parameter Type: Configurable
OIM Menu Path(s): Network Communications
Selects whether the drive reference is from the designated register in the drop
register image or from one of the eight network broadcast registers when
CONTROL
SOURCE SELECT is set to NETWORK .
NETW REGISTER MAP SEL
(P.914)
Indicates which
register map
configuration will be
used for the AutoMax
Network
Communication kit. Parameter Range: 1 = ORIGINAL
2 = ALTERNATE
Default Setting: 1
Parameter Type: Configurable
OIM Menu Path(s): Additional Parameters (listed by parameter number)
ALTERNATE selects the new register map, which permits use of additional functions.
ORIGINAL should be used if you need to maintain compatibility with older FlexPak
drives that do not have a selectable register map (V3.12 and earlier).