Rockwell Automation 1397 DC Drive Firmware 2.xx - Manual (Page 259)

Using SCANport Capabilities D–9
Publication 1397-5.0 — June, 2001
Serial Communications Module:
The following figure shows how the I/O image table for the
programmable controller relates to the 1397 Drive when a Serial
Communications Module is used.
1203–Gx2
DF1/DH485 to SCANport
N40:0–63 BTW Emulation
N41:0 ➀ Logic Command
N41:1
➀
Reference
N41:2
➀
Datalink A1
N41:3
➀
Datalink A2
N41:4
➀
Datalink B1
N41:5 ➀ Datalink B2
N41:6 ➀ Datalink C1
N41:7 ➀ Datalink C2
N41:8
➀
Datalink D1
N41:9
➀
Datalink D2
1397 Drive PLC, SLC,
or PC
DF1/DH485
Serial Messages
(Write)
DF1/DH485
Serial Messages
(Read)
Logic Command
Data In A1 (p. 226)
Data In A2 (p. 227)
Data In B1 (p. 228)
Data In B2 (p. 229)
Data In C1 (p. 230)
Data In C2 (p. 231)
Data In D1 (p. 232)
Data In D2 (p. 233)
Logic Status (p. 190)
Spd Loop Fdbk (p. 022)
Data Out A1 (p. 234)
Data Out A2 (p. 235)
Data Out B1 (p. 236)
Data Out B2 (p. 237)
Data Out C1 (p. 238)
Data Out C2 (p. 239)
Data Out D1 (p. 240)
Data Out D2 (p. 241)
N40:0–63 BTR Emulation
N41:0
➀
Logic Status
N41:1
➀
Feedback
N41:2 ➀ Datalink A1
N41:3 ➀ Datalink A2
N41:4
➀
Datalink B1
N41:5
➀
Datalink B2
N41:6
➀
Datalink C1
N41:7
➀
Datalink C2
N41:8 ➀ Datalink D1
N41:9 ➀ Datalink D2
SCANport
➀ Optionally enabled using
DIP switches on the adapter.