Rockwell Automation 22D PowerFlex 40P User Manual, FRN 3 - Manual (Page 59)

Programming and Parameters 3-13
Basic Program Group (continued)
P039 [Accel Time 1]
Related Parameter(s): P038 , P040 , A051 - A054 ,
A067 , A070 - A077 , A140 - A147
Sets the rate of acceleration for all speed increases.
Values Default: 10.0 Secs
Min/Max: 0.0/600.0 Secs
Display: 0.1 Secs
Maximum Freq
Accel Time
Accel Rate =
Speed
0
Time
P035 [Maximum Freq]
P039, A067,
E203 or E205
[Accel Time x] P040, A068,
E204 or E206
[Decel Time x]
0
Acceleration
Deceleration
P040 [Decel Time 1]
Related Parameter(s): P038 , P039 , A051 - A054 ,
A068 , A070 - A077 , A140 - A147
Sets the rate of deceleration for all speed decreases.
Values Default: 10.0 Secs
Min/Max: 0.0/600.0 Secs
Display: 0.1 Secs
Maximum Freq
Decel Time
Decel Rate =
Speed
0
Time
P035 [Maximum Freq]
P039, A067,
E203 or E205
[Accel Time x] P040, A068,
E204 or E206
[Decel Time x]
0
Acceleration
Deceleration
P041 [Reset To Defalts]
Stop drive before changing this parameter.
Resets all parameter values to factory defaults.
Options 0 “Ready/Idle” (Default)
1 “Factory Rset”
•
After the reset function is complete, this parameter will set
itself back to “0”.
•
Causes an F48 Params Defaulted fault.