Rockwell Automation 22D PowerFlex 40P User Manual, FRN 3 - Manual (Page 49)

Programming and Parameters 3-3
Basic Display Group
b001 [Output Freq] Related Parameter(s): b002 , b010 , P034 , P035 , P038
Output frequency present at T1, T2 & T3 (U, V & W).
Values Default: Read Only
Min/Max: 0.00/ P035 [Maximum Freq]
Display: 0.01 Hz
b002 [Commanded Freq]
Related Parameter(s): b001 , b013 , P034 , P035 , P038
Value of the active frequency command. Displays the commanded frequency even if the drive is not
running.
Important: The frequency command can come from a number of sources. Refer to
Start and Speed
Reference Control on page 1-27 for details.
Values Default: Read Only
Min/Max: 0.00/ P035 [Maximum Freq]
Display: 0.01 Hz
b003 [Output Current]
The output current present at T1, T2 & T3 (U, V & W).
Values Default: Read Only
Min/Max: 0.00/(Drive Rated Amps
×
2)
Display: 0.01 Amps
b004 [Output Voltage]
Related Parameter(s): P031 , A084 , A088
Output voltage present at terminals T1, T2 & T3 (U, V & W).
Values Default: Read Only
Min/Max: 0/Drive Rated Volts
Display: 1 VAC
b005 [DC Bus Voltage]
Present DC bus voltage level.
Values Default: Read Only
Min/Max: Based on Drive Rating
Display: 1 VDC