Enhanced program group, Continued), E212 [traverse dec – Rockwell Automation 22D PowerFlex 40P User Manual, FRN 3 User Manual
Page 100: E213 [p jump, E214 [sync time, E215 [speed ratio
3-54
Programming and Parameters
Enhanced Program Group
(continued)
E212 [Traverse Dec]
Related Parameter(s):
Sets time required for the Traverse function to decelerate from the maximum to the minimum traverse
frequency. Refer to the diagram at
[Max Traverse].
Values
Default:
0.00 Secs
Min/Max:
0.00/30.00 Secs
Display:
0.01 Secs
E213 [P Jump]
Related Parameter(s):
Sets the frequency amplitude that is added to or subtracted from the commanded frequency. Refer to
the diagram at
[Max Traverse].
Values
Default:
0.00 Hz
Min/Max:
0.00/300.0 Hz
Display:
0.01 Hz
E214 [Sync Time]
Related Parameter(s):
Enables the function that holds the drive at the current frequency even if the commanded frequency
changes. Used with
[Digital Inx Sel] option 31 “Sync Enable”.
Values
Default:
0.0 Secs (Disabled)
Min/Max:
0.0/3200.0 Secs
Display:
0.1 Secs
Hertz
Time
Speed Sync Bit
Change Ref's
214 [Sync Time]
Drive #1 and #2 Sync Enable Input
d302 [Fiber Status]
New Drive #1 Reference
New Drive #2 Reference
E215 [Speed Ratio]
Stop drive before changing this parameter.
Enables the function that scales the drive speed command.
Values
Default:
1.00
Min/Max:
0.01/99.99
Display:
0.01