D310, D310 [fault 4 code, D311 [fault 5 code – Rockwell Automation 22D PowerFlex 40P User Manual, FRN 3 User Manual
Page 110: D312 [fault 6 code, D313 [fault 7 code
3-64
Programming and Parameters
d310 [Fault 4 Code]
Related Parameter(s):
(With FRN 3.xx and later.)
A code that represents the fourth most recent drive fault. The codes will appear in these parameters in
the order they occur (
[Fault 1 Code] = the most recent fault). Repetitive faults will only be
recorded once. As faults occur, the value of this parameter will be moved to [Fault 5 Code] and this
parameter will be overwritten by [Fault 3 Code].
Refer to
for fault code descriptions.
Values
Default:
Read Only
Min/Max:
0/122
Display:
1
d311 [Fault 5 Code]
Related Parameter(s):
(With FRN 3.xx and later.)
A code that represents the fifth most recent drive fault. The codes will appear in these parameters in
the order they occur (
[Fault 1 Code] = the most recent fault). Repetitive faults will only be
recorded once. As faults occur, the value of this parameter will be moved to [Fault 6 Code] and this
parameter will be overwritten by [Fault 4 Code].
Refer to
for fault code descriptions.
Values
Default:
Read Only
Min/Max:
0/122
Display:
1
d312 [Fault 6 Code]
Related Parameter(s):
(With FRN 3.xx and later.)
A code that represents the sixth most recent drive fault. The codes will appear in these parameters in
the order they occur (
[Fault 1 Code] = the most recent fault). Repetitive faults will only be
recorded once. As faults occur, the value of this parameter will be moved to [Fault 7 Code] and this
parameter will be overwritten by [Fault 5 Code].
Refer to
for fault code descriptions.
Values
Default:
Read Only
Min/Max:
0/122
Display:
1
d313 [Fault 7 Code]
Related Parameter(s):
(With FRN 3.xx and later.)
A code that represents the seventh most recent drive fault. The codes will appear in these parameters
in the order they occur (
[Fault 1 Code] = the most recent fault). Repetitive faults will only be
recorded once. As faults occur, the value of this parameter will be moved to [Fault 8 Code] and this
parameter will be overwritten by [Fault 6 Code].
Refer to
for fault code descriptions.
Values
Default:
Read Only
Min/Max:
0/122
Display:
1