ETC Cobalt Family v7.1.0 - Manual (Page 575)

Cobalt 7.1 - 20140612
574
Selection logic for channel selection from numerical keypad with default Cobalt syntax (RPN mode).
See also
Select Channels >>
Select Function Key Explanation
Select complete device [1] [CHANNEL] Selects the base channel and
all decimal channels
Select only base channel [1] [.] [0]
[CHANNEL]
Selects only the base channel.
Works with
PLUS/MINUS/THRU
Select only decimal
channels [1] [.] [1]
[CHANNEL] Selects only the decimal
channel.
Works with
PLUS/MINUS/THRU
Invert base/decimal [INVERT] & [.] Inverts the current selection
between base channels and
decimal channels
Clear selected channels
[C/Alt] [C/Alt]
Clear
Selection logic for channel selection from numerical keypad with AT Mode. Note that a channel will
not appear to be selected on the screen until the next command is pressed, such as @LEVEL.
Select Function Key Explanation
Select complete device
[1]
Selects the base channel and all
decimal channels
Select only base channel [1] [.] [0] Selects only the base channel.
Works with
PLUS/MINUS/THRU
Select only decimal
channels [1] [.] [1] Selects only the decimal
channel.
Works with
PLUS/MINUS/THRU
Invert base/decimal [INVERT] & [.] Inverts the current selection
between base channels and
decimal channels
Terminate a selection
command [.] [.] To terminate a channel
selection without pressing
@LEVEL, press the decimal
point twice.
Clear selected channels
[C/Alt] [C/Alt]
Clear