ETC Cobalt Family v7.1.0 - Manual (Page 332)

Cobalt 7.1 - 20140612
331
2. Enter the number of the group you just recorded and press GROUP - these channels should
now be selected
NOTE: If you are operating in the At Mode syntax you select a group by pressing GROUP followed
by the group number.
Assign this Group to a master:
1. Enter the number of the Group
2. Hold GROUP and press a master key. This group is now assigned to this master. If the group
has intensities stored they will apply when the master is raised. To select the channels in this
group, press the master key.