ETC Cobalt Family v7.1.0 - Manual (Page 288)

Cobalt 7.1 - 20140612
287
NOTE
The Output List is divided into DMX universes. Open each from the Browser
>Patching >Output List >Universe #
Output List - Columns & Functions
Column Input Function
Output (EDMX)* No input The number of this Output (and EDMX) -
cannot be edited here.
Channel 0-3072 Enter the number, followed by MODIFY.
Proportion 0-100% Sets a proportional scaling factor for the
intensity of this output (channels can be
scaled in the Channel List).
Curve dropdown Shows the output curve. See Dimmer
Curves .
Device Info No Input Shows the moving device template and
parameter assigned to this output. Cannot be
edited - see
Device Settings .
Park 0-100% Shows the level an output is parked at. Set a
level with # MODIFY and remove with C &
MODIFY. See
Park .
*Output Lists show EDMX numbers in ( ) after the offset.port numbers in the first column. This is a
direct translation of EDMX values calculated using the EDMX Start value in the Settings dialog
(Cobalt output 1.1 = the EDMX Start number, and all subsequent outputs are calculated from there).