ETC Cobalt Family v7.1.0 - Manual (Page 279)

Cobalt 7.1 - 20140612
278
address.universe. You can change universe
by ".universe"
Inv. Pan Off/On You can invert pan for this device on the
input (manual control) or output (stored
data)
Inv. Tilt Off/On You can invert tilt for this device on the
input (manual control) or output (stored
data)
Swap Pan/Tilt Off/On Swap pan/tilt for this device.
Scroller Roll Dropdown
menu Shows the assigned scroller roll - dropdown
to change. See
Scroller Rolls .
Calibration Editor [MODIFY] Press MODIFY to open the Calibration
Editor for a specific scroller roll. See
Calibrate Individual Scroller Rolls .
Device Settings - Patching
It is possible to Patch devices directly into the Device Settings tab. You can use any channel selection
to patch fast.
Function Key Feedback
Insert a new
Device
[#] [INSERT]
A new Device is inserted.
Delete the selected
Device [DELETE] The selected Device is deleted. You
can only delete one device at a time.
Insert the current
channel selection
as devices [INSERT] The current channel selection is
inserted as Devices.
Change template
for multiple
devices
[SELECT]
Use SELECT to select multiple
cells. Select a new template from
the dropdown and press MODIFY *
Change address for
multiple devices [SELECT] Use SELECT to select multiple
cells. Enter a start address and press
MODIFY.
Unpatch a device [0] [MODIFY] In the Adress cell you can unpatch
the currently selected devices by
entering 0.
*If a template isn't available, use the Import Template Wizard to import it. See Import
Template Wizard .