Brother PE-DESIGN V7 - Manual (Page 46)

40
Tutorial
To change the direction of the fill stitching,
click Constant, move the pointer over the red
arrow inside of the circle, and then drag the
red arrow to the desired angle.
Click the regions of the leaves to which you
want to apply the attributes.
→ “Marching lines” appear around the
selected region.
In the same way, specify the color and sew
type for all regions of the leaves.
→ After applying the sewing attributes to the
leaves, the image appears as shown
below.
As with the leaves, specify the sewing
attributes for part of the flower. Select the color
CARMINE, set the stitching direction, and
then click each region where you want to apply
the attributes.
a
Note:
Sewing attributes cannot be applied to
regions that are not fully enclosed, as shown
in the illustration of the leaf below.
If the attributes cannot be applied to a
region, go back to Figure Handle stage and
make sure that region is closed. Edit any
broken lines with the Point Edit tool. (For
more details, refer to “Reshaping outlines”
on page 205.)