Brother PE-DESIGN V7 - Manual (Page 198)

192
Arranging Embroidery Designs (Layout & Editing)
6.
Continue hooping the fabric and embroidering
until the entire embroidery design is sewn.
3) Hoop the fabric for the lower-left design
section with the top of the hoop aligned
on the alignment stitching at the bottom
of the design section sewn in step 1, and
then embroider the design.
→
Before the design section is
embroidered, alignment stitching is
sewn at the top. Make sure that this
alignment stitching aligns with the
alignment stitching sewn in step 1.
After the design section is
embroidered, alignment stitching is
sewn on the right side of the design
section.
4) Hoop the fabric for the lower-right design
section with the left side of the hoop
aligned on the alignment stitching on the
right side of the design section sewn in
step 3 and with the top of the hoop
aligned on the alignment stitching at the
bottom of the design section sewn in
step 2, and then embroider the design.
→
Before the design section is
embroidered, alignment stitching is
sewn on the left side and at the top.
Make sure that this alignment
stitching aligns with the alignment
stitching sewn in step 3 and in step 2.