Brother PE-DESIGN V7 - Manual (Page 326)

320
Tips and Techniques
• When satin stitching is sewn in a wide area, the stitched area may shrink after sewing, depending on the
material and the type of thread used. If this happens, switch to this alternate method: Select the fill stitch
and use stabilizer material on the reverse side of the fabric.
Tips for Importing Images for Design
Center
Refer to the following when importing images for Design Center.
■
When scanning illustrations
• If the outline is not clear, trace the outline on tracing paper.
• Better scanning results may be produced by reducing the tone of the image.
Pattern
After sewing
a
Note:
When using the satin stitch in a wide area, the needle may move out of position by about 10 mm with some
machines. In order to avoid this, use the above-mentioned alternate method.