Brother PE-DESIGN V7 - Manual (Page 322)

316
Tutorial (Advanced)
Step 5 Transferring the design to an
original card
By writing a design to a media that can be used in
your embroidery machine and transferring it to
your embroidery machine, you can actually sew
the design. For this example, we will transfer the
design to an original card.
Insert an original card into the USB card
writer module.
Transfer the embroidery design.
Click File, then Write to Card.
→ The following message appears.
Click OK.
→ The following message appears.
Click OK.
Quit Layout & Editing.
Click File, then Exit.
b
Memo:
For other media you may use include floppy
disks, compact flash memory, USB media and
etc.
a
Note:
The original card is inserted correctly when
you hear it snap into place.
1
2
a
Note:
Before using the original card, make sure
that the designs on the card are no longer
needed or make sure to store them on your
hard drive or other storage media.
a
Note:
• If the card writer module is not correctly
connected or powered, an error message
of “No card writer module is connected.
Please connect card writer module.” will
appear.
• If the original card is not inserted or is
defective, an error message of “No
original card is inserted. Please insert an
original card.” will appear.
3